1. Introduction

Antelope Audio’s integrated EQ offers 5 fully parametric bands. Two of those can work in filter or shelving mode, and the three in the middle can cut or boost selected frequency ranges. Our users have been using this simply designed, yet perfect-sounding plug-in for both tracking and mixing, as it provides all that you might need in an EQ.

2. Features

  • Five parametric bands with selectable frequencies
  • Five gain adjustment knobs
  • Five Q width adjustment knobs
  • Graphic display
  • Output gain meter

3. Layout

Parametric EQ Layout

1. Frequency Adjustment Knobs

Specify up to five frequency bands for equalization.

2. Gain Adjustment Knobs

Specify the amount of gain applied to a particular band.

3. Q Width Adjustment Knobs

Specify the Q width of a particular band.

4. Graphic Display

Visualizes the equalization curves.

5. Output Gain Meter

Visualizes output gain.

4. Contacts

Having difficulties with the Parametric EQ or anything else Antelope? Get in touch with us by the following means:

European Direct Support Line
+44 2039578550
10:00 a.m. – 10:00 p.m. (EET), Monday – Friday
USA Direct Support Line
+1 734 418 8661
7:00 a.m. – 6:30 p.m. (EST), Monday – Friday
Online (live chat and e-mail)
Antelope Audio Support Page

5. Glossary

5.1 Shelving EQ
A shelf type EQ is the boost or cut of all frequencies above or below the cutoff frequency. It is most commonly found on the top and bottom bands of a parametric EQ.
5.2 Bell Curve
All equalizers with peaking filters use a bell curve which makes the EQ smoothly process a range of frequencies. With the bell curve, the center frequency occurs at the top of the bell curve and is the one most affected by equalization.
5.3 Low-cut Filter
Also known as high-pass filter. There are two types of pass filters in equalization. A high-pass filter (HPF) attenuates content below a cutoff frequency, allowing higher frequencies to pass through the filter. Thus, it is commonly used for cutting low frequencies. A low-pass filter (LPF) works the opposite – it attenuates content above a cutoff frequency, letting lower frequencies pass through the filter.